Online Shop

(19 items) 1 page

GliderCG SCALE

$0.00
GliderCG Scale is our bigger CoG balancer for models from 200g to 40Kg.

GliderThrow

$216.00
GliderCG Tools for Competition Glider GliderThrow digital Angle/Throw meter and … Differentials!

GliderCG F3K

$270.00
The family grows, GliderCG for F3K DLG! New specific design for the latest F3K models with small wing chord. For all those DLG models, with this new device the flaps will not lean on the rear support pads but on the wing. The new distance between the front pin an the rear support pad is 117mm. In the standard GliderCg device this distance is 150mm

GliderCG Tools for Competition Glider

$324.00
GliderCG Plus Sin ti´tulo GliderCG Plus is an evolution of the design of GliderCG that uses the same concept to be able to be used in large sailplanes and airplanes of up to 15kg.

HP-EOS Sentry3

$35.00
EOS Sentry3 2~8S Battery Checker & Balancer, with Store Mode Discharge

HP-RXLOADTEST

$19.30
Receiver Battery Load Tester

HP-RXMONITOR

$19.30
Onboard Receiver Battery Volt Indicator

HP-EM2

$103.50
Emeter II Emeter V2 handheld device for use with RDU, RDU required for measurements - look to HP-EM2-SET and HP-EM2-DLX for complete package.

HP-EM2-4PINCBL

$8.20
Emeter II <-> RDU Data Cable

HP-EM2-DLX

$225.00
Emeter II DELUXE SET

HP-EM2-LDU

$27.40
The Hyperion LDU (local data unit) is an inexpensive alternative to the RDU unit, for bench testing.It must be connected to the Emeter II during test runs.It has the full functionality of the RDU, except for the Height (altitude) indicator.

HP-EM2-MDU

$47.00
HP-EM2-MDU Hyperion Micro Data Unit (MDU) for Emeter II •Max input voltage: 35 V •Continuous current: 25 A •Peak current: 50 A / 5 seconds •Can be used without Emeter - Interface cable and PC software required to read data (software is free)

HP-EM2-PWRCBL

$5.20
Emeter II Power Input Cable

HP-EM2-RDU

$82.40
Remote Data Unit (RDU) for Emeter II Included in Emeter V2 sets HP-EM2-SET and HP-EM2-DLX, Can be used without Emeter - PC software required to read data (software is free)

HP-EM2-SD-2GB

$16.40
Genuine SanDisk 2GB SD Card for Emeter II

HP-EM2-SET

$180.00
Emeter II SET Ready-to-go set with RDU and necessary cables, Tach and temp sensors optional - consider HP-EM2-DLX for complete package at savings!

HP-EM2-TACHBL

$13.00
RDU Phase Tachometer for brushless motors

HP-EM2-TMP1

$13.70
Ext. Temp Sensors no 1 for Emeter II RDU

HP-EM2-TMP23

$27.40
Ext. Temp Sensors no 2 and 3 for Emeter II RDU
(19 items) 1 page